Aethra d2061 Mode D'Emploi
QUICK GUIDE
D2061 ADSL TESTER
IP over PPP is used on links where an initial authentication phase is needed.
Authentication: Assign the authentication mode for IP over PPP protocols. With
the value ‘PAP and CHAP’, the device carries out the authentication in one mode
and only if fails, it tries to use the remaining one. This allows to ignore the
authentication protocol used by PPP server.
the value ‘PAP and CHAP’, the device carries out the authentication in one mode
and only if fails, it tries to use the remaining one. This allows to ignore the
authentication protocol used by PPP server.
User Name: Enter the User name for the identification. Only for IP over PPP.
Password: Enter the User password. Only for IP over PPP.
IP address mode: Select the User IP address mode
•
Static: The IP address is manually configured by the User.
•
Dynamic: An assignment request of the User’s IP address is sent to the
Server by using the DHCP protocol. Only for IP over PPP.
Server by using the DHCP protocol. Only for IP over PPP.
Local IP: Enter the local IP address. Only in ‘IP address mode: Static’.
PPP type: Allows to select the PPP protocol simulation type performed by the
device:
•
device:
•
Client: The D2061 simulates a user terminal, with authentication request to a
remote server.
remote server.
•
Client + link verify: The device, in Client simulation, sends an echo request
every ten seconds in order to verify if the link is still active.
every ten seconds in order to verify if the link is still active.
•
Server: The D2061 simulates a server and allows to verify the authentication
phase coming from a remote terminal.
phase coming from a remote terminal.
•
Server + link verify: The device, in Server simulation, sends an echo
request every ten seconds in order to verify if the link is still active.
request every ten seconds in order to verify if the link is still active.
LLC SNAP: Setup the packets’ routing mode. Choose Yes, to route the packets
with an LLC SNAP header.
with an LLC SNAP header.
This method allows multiplexing of multiple protocols over a single ATM virtual
circuit. The protocol of a carried Protocol Data Unit (PDU) is identified by prefixing
the PDU by a Logical Link Control (LLC) header.
circuit. The protocol of a carried Protocol Data Unit (PDU) is identified by prefixing
the PDU by a Logical Link Control (LLC) header.
Choose No, to route the packets according to the VC in use. This second method
does higher-layer protocol multiplexing implicitly by ATM Virtual Circuits (VCs). It
is called "VC Based Multiplexing".
does higher-layer protocol multiplexing implicitly by ATM Virtual Circuits (VCs). It
is called "VC Based Multiplexing".
DNS server: Enter the DNS address which allows the solution of names from IP
to URL and vice versa.
to URL and vice versa.
Start the test.
28