Aethra d2061 Mode D'Emploi

QUICK GUIDE 

D2061 ADSL TESTER 

 

► 

The LED STATUS is OFF if no test running, is ON (solid green) 

during regular test running. 

► 

The LED LINK is OFF if the physical connection is not active, is 

ON (solid yellow) during the connection phase, is ON (solid green) 
when the connection is active, is ON (solid red) when an error 
occurs. 

The test results displayed are the following: 

The Status line indicates the status of the test and the TFTP line indicates the 
status of the file in transfer: Uploading, Downloading, Complete and, at the end of 
the test, the disconnection causes.  

► 

Date, time and elapsed time 

► 

Number of the cycle in progress 

► 

Blocks, Bytes and Throughput, in Kbps, received in Downstream 

and transmitted in Upstream. Data depend on the length of the file 
transferred and on the type of transfer simulated.  

► 

Local, Server and Destination IP address 

► 

Transmitted errors both in Downstream and Upstream 

► 

Minimum, average and maximum Throughput, in Kbps, received 

in Downstream and transmitted in Upstream.  

It’s also possible to interrupt the actual IP traffic phase, change the setup and 
start a new IP traffic generation. 

With the softkey Break is possible to interrupt the actual 
Ping phase and change the remote IP. 

To change the destination IP address and/or the other 
parameters.  

To start a new Ping traffic generation using the same 
internet connection. 

With this test it is possible to verify the quality of the line measuring the noise 
present. Perform the test in order to point out possible troubles and cross talks 
with frequencies up to 1.1MHz.  

Open the TEST MENU. 

                                                                  29