Vidikron model 10 Manuel D’Utilisation

Information: Select Information from the Main Menu to see information about the current 
source, input resolution, horizontal and vertical frequencies, lamp hours and the installed 
firmware version. 

Should you ever need to contact Vidikron Technical Support, this information will help them 
answer your questions or resolve product performance issues. 

Restore Factory Settings: To reset all items in the Image Options menu to their factory 
default values, select Restore Factory Settings and press ENTER. A warning message appears; 
press ENTER again to confirm the reset or press EXIT to cancel. After the reset, the projector 
powers off and restarts.

The Installation menu to change the picture orientation, appearance and behavior of the 
OSD menus, fan speed and other projector settings. 

Language: Select Language from the Installation menu and press the right- or left-arrow 
buttons to select the OSD language (English, French, Italian, German or Spanish).

Picture Configuration: Select Picture Configuration from the Installation menu to change 
the picture orientation to suit the method of installation (Floor Front, Floor Rear, Ceiling 
Front or Ceiling Rear). 

OSD Timeout: The OSD Timeout setting controls how long the OSD menus stay on screen 
when no buttons are pressed. Select a time-out period of 5, 15 or 60 seconds. 

OSD Transparent: To allow the projected image to show through the OSD menus, select 
OSD Transparent from the Installation menu and set it to ON.

Source Detect: The Vision 10/12 can automatically detect an incoming signal and switch to 
that input. To enable automatic source detection, select Source Detect from the Installation 
menu and set it to Auto. 

Auto Power Off: The Vision 10/12 can be set to power off automatically after 15 minutes of 
no input signal or user input via the remote control. To enable this feature, set it to ON. When 
you do, a warning message appears on-screen five minutes before the shutdown is to occur. 
To prevent the projector from powering off, press any key on the remote control. 

Blue Enable: Blue Enable removes all red and green color information from the image, 
simulating a blue filter. You can use it instead of a blue filter when performing color and tint 
adjustments. 

OSD Position: To change the position of the OSD controls, select OSD Position from the 
Installation menu. Use the up- and down-arrow buttons to select Top Left, Bottom Left, Top 
Right or Bottom Right, then press ENTER.

➤