Bizfon 2000 Mode D'Emploi
Bizfon Manual II: Administrator's Guide
Administrator’s Menus
Bizfon2000 and Bizfon4000 (SW Version 4.1.x)
13
The area Receive Values provides the following:
•
Receive Bytes - number of received bytes.
•
Receive Packets - number of received Ethernet
packets.
•
Receive Errors - number of received packets
containing errors.
•
Receive Drop Errors - number of received packets that
have been discarded.
•
Receive Overrun Errors - number of received overrun
errors that occur when the receive buffer is not large
enough to hold all incoming packets. This error usually
appears due to a slow receiving system.
enough to hold all incoming packets. This error usually
appears due to a slow receiving system.
•
Receive MultiCast Packets - number of received
broadcast packets.
The area Transmit Values provides the following:
•
Transmit Bytes - number of transmitted bytes
•
Transmit Packets - number of transmitted Ethernet
packets.
packets.
•
Transmit Errors - number of transmitted packets
containing errors.
containing errors.
•
Transmit Drop Errors - number of transmitted packets
that have been discarded.
that have been discarded.
•
Transmit Carrier Errors - number of transmit carrier
errors that occur due to a defective or lost connection on
the Ethernet link.
errors that occur due to a defective or lost connection on
the Ethernet link.
•
Transmit Collisions - number of transfer errors that
occurred during a simultaneous packet transmission
from both sides.
occurred during a simultaneous packet transmission
from both sides.
Fig. II-15: Transfer Statistics Diagram Chart
To see the Transfer Statistics Diagram Charts, select the desired criteria and click Save to generate the corresponding chart and the table
showing the transfer statistics values (if enabled). The letters M (millions) and K (thousands) used in the legend of the displayed diagrams show the
total number of specified criteria. The Reset Statistics button is used to reset the chart and the table (if enabled).
showing the transfer statistics values (if enabled). The letters M (millions) and K (thousands) used in the legend of the displayed diagrams show the
total number of specified criteria. The Reset Statistics button is used to reset the chart and the table (if enabled).
Lines Status
The Bizfon Status - Lines Status page shows the current status of each of the FXS, IP and FXO lines including details of the attached extension.
Since only one line of information can be displayed at a time, the Line, IP Line and FXO functional buttons are used to navigate through the
information regarding other lines.
Since only one line of information can be displayed at a time, the Line, IP Line and FXO functional buttons are used to navigate through the
information regarding other lines.
The Lines Status table displayed for FXS and IP lines includes a group of static and dynamic parameters. Static parameters are always displayed.
Dynamic parameters only appear when an event takes place on the extension.
Dynamic parameters only appear when an event takes place on the extension.