Canon MF5880dn Guide D’Installation Rapide

13

The machine is compatible with a category 5 
or greater twisted pair LAN cable. Connect 
one end to the 10Base-T/100Base-TX port on 
the back of the machine and the other end 
to a network router or a hub.

Connect a LAN cable that is compatible with the 
LAN connector of this machine.

A LAN cable is not included with the machine.

By default, the IP address is assigned to the 
machine automatically by the DHCP server. 
Therefore, all you need to do when using DHCP is 
just to connect the LAN cable. After connecting 
the LAN cable, wait until the machine gets the IP 
address.

To make sure this machine is communicating to 
the network properly, follow the procedure in this 
section.

It is recommended that the network administrator 
perform this procedure.
Before performing this procedure, make sure that the 
machine is turned ON and connected to a network.
For instructions on the settings for IPv6, see “Network 
Settings,” in the e-Manual.
The settings for the Static IP, see “Network Settings,” in 
the e-Manual.

–

–

–

–

The machine may enter the standby mode (Auto Clear function) while you 
are setting it up. Make the setting again from the main menu.

The machine may enter the Sleep mode while you are performing setup. 
Press   [Energy Saver] to turn the display back ON and continue the setup.

Press   [Menu].

Press 

 or 

 to select <10. SYSTEM 

SETTINGS>, then press [

OK

].

Press 

 or 

 to select <5. NETWORK 

SETTINGS>, then press [

OK

].

Press 

 or 

 to select <1. TCP/IP 

SETTINGS>, then press [

OK

].

Press 

 or 

 to select <1. IPv4 

SETTINGS>, then press [

OK

].

Press 

 or 

 to select <3. VIEW IP 

ADDRESS>, then press [

OK

].

●

●