Newco gxdf-8d Mode D’Emploi
6
COFFEE PREPERATION PROCEDURES
1) Place filter into brew basket.
2) Put the appropriate amount of ground coffee into the filter for the volume of coffee being brewed.
3) Slide the brew basket into holder.
4) Set the volume selection switch to the appropriate position for the volume of coffee being brewed.
5) For warmer units:
Place empty decanter on warmer located directly under the brew basket.
Turn corresponding warmer switch to ON position.
For dispenser units:
Remove the dispenser lid unless it is a brew through design.
Place the dispenser directly under the brew basket.
For dispenser units:
Remove the dispenser lid unless it is a brew through design.
Place the dispenser directly under the brew basket.
6) Press brew start/stop switch. Note: a brew cycle may be initiated even if the heating light is on.
7) If the autoarm feature is enabled the heating light will begin to flash indicating that the brewer is heating and will
begin to brew immediately after the heating cycle is complete. Do not remove decanter. Brew cycle may be canceled
by depressing the brew start/stop switch. The heating light should no longer be flashing.
by depressing the brew start/stop switch. The heating light should no longer be flashing.
8) Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed within
the brew basket. The coffee brew will drain from the brew basket into the decanter below.
9) The status brewing light should continue to flash until all the liquid has finished flowing from the brew basket. Do not
remove decanter until the brewing process has stopped and all liquid has stopped flowing from the brewbasket.
10) The resultant coffee brew should be crystal clear and have the desired properties attainable through excellent
extraction.
11) To clean brew basket simply remove from brew rails and dump filter into wastebasket. The brewing process, as
described above, can now be started again.
GXD SERIES REPLACEMENT PARTS LIST
110307
PDS Valve Assembly, High Flow
108143
Control Board (A)
100251
Valve, Solenoid, Hemco
108225
Control Board (B)
152114
Dump Valve, Solenoid
100008
Warmer Plate, Black Porcelainized
102770
Faucet Assembly
202053
Element, Warmer, 120W/120V (Mod -15)
701985
Tube Assembly, Sprayhead
110959
Element, Warmer, 150W/120V (Mod -30)
701483
Sprayhead Assembly
102841
Micro Switch, Faucet
100025
Gasket, Sprayhead
201985
Switch, Start, Black
701870
Tank Assembly, 5500W/240V, 1 Phase
700434
Switch, SPST Black (I, II Volume Select)
701875
Tank Assembly, 10500W/240V, 3 Phase
100085
Switch, Lighted SPST, Red Rocker
701286
Tank Element, 5500W/240V
701449
Light, Visa, Red
701760
Tank Element, Five Loop, 3500W/240V
100236
Light, Heating
701690
Tank Element, Triple Loop, 3500W/240V
701714
Brew Basket, Plastic
701619
Tank Element, 6000W/208V
701713
Brew Basket, S/S
701695
Tank Element, 6600W/240V
701527
Brew Basket, Gourmet, S/S
701305
Thermostat, Manual Reset