Newco gxdf-8d 작동 가이드

다운로드
페이지 7
COFFEE PREPERATION PROCEDURES 
 
1)  Place filter into brew basket. 
 
2)  Put the appropriate amount of ground coffee into the filter for the volume of coffee being brewed. 
 
3)  Slide the brew basket into holder. 
 
4)  Set the volume selection switch to the appropriate position for the volume of coffee being brewed. 
 
5)  For warmer units: 
  
    Place empty decanter on warmer located directly under the brew basket. 
          Turn corresponding warmer switch to ON position. 
For dispenser units:       
          Remove the dispenser lid unless it is a brew through design. 
          Place the dispenser directly under the brew basket. 
 
6)  Press brew start/stop switch. Note: a brew cycle may be initiated even if the heating light is on. 
 
7)  If the autoarm feature is enabled the heating light will begin to flash indicating that the brewer is heating and will 
begin to brew immediately after the heating cycle is complete. Do not remove decanter. Brew cycle may be canceled 
by depressing the brew start/stop switch. The heating light should no longer be flashing. 
 
8)  Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed within 
the brew basket. The coffee brew will drain from the brew basket into the decanter below. 
 
9)  The status brewing light should continue to flash until all the liquid has finished flowing from the brew basket. Do not 
remove decanter until the brewing process has stopped and all liquid has stopped flowing from the brewbasket. 
 
10) The resultant coffee brew should be crystal clear and have the desired properties attainable through excellent 
extraction. 
 
11) To clean brew basket simply remove from brew rails and dump filter into wastebasket. The brewing process, as 
described above, can now be started again. 
 
 
GXD SERIES REPLACEMENT PARTS LIST 
 
 
110307 
PDS Valve Assembly, High Flow  
108143 
Control Board (A) 
100251 
Valve, Solenoid, Hemco 
108225 
Control Board (B) 
152114 
Dump Valve, Solenoid 
100008 
Warmer Plate, Black Porcelainized 
102770 
Faucet Assembly 
202053 
Element, Warmer, 120W/120V (Mod -15) 
701985 
Tube Assembly, Sprayhead 
110959 
Element, Warmer, 150W/120V (Mod -30) 
701483 
Sprayhead Assembly 
102841 
Micro Switch, Faucet 
100025 
Gasket, Sprayhead 
201985 
Switch, Start, Black 
701870 
Tank Assembly, 5500W/240V, 1 Phase 
700434 
Switch, SPST Black (I, II Volume Select) 
701875 
Tank Assembly, 10500W/240V, 3 Phase 
100085 
Switch, Lighted SPST, Red Rocker 
701286 
Tank Element, 5500W/240V 
701449 
Light, Visa, Red 
701760 
Tank Element, Five Loop, 3500W/240V 
100236 
Light, Heating 
701690 
Tank Element, Triple Loop, 3500W/240V  
701714 
Brew Basket, Plastic 
701619 
Tank Element, 6000W/208V 
701713 
Brew Basket, S/S 
701695 
Tank Element, 6600W/240V 
701527 
Brew Basket, Gourmet, S/S 
701305 
Thermostat, Manual Reset