Nortel 4000 Note De Mise
95
Remote Access Software Version 5.3 Release Notes
300115-B Rev. A
To restore a RAC’s configuration:
1.
At the command prompt, enter the following:
command: annex <IP address*>
This identifies which RAC you want for subsequent commands.
2.
(For UNIX)
command: read <filename.param >
(For Windows NT)
command: read <filename.txt>
This copies the filename.param file to the RAC that you specified
and changes the parameters to ones specified in the file.
and changes the parameters to ones specified in the file.
3.
command: quit
This exits na.
The following is a sample of login and read commands on a UNIX host
(on Windows NT, only the first line is different):
(on Windows NT, only the first line is different):
#/usr/annex/na
command: Annex 192.32.30.49
Password for 192.32.30.49 <unknown>: abd
192.32.30.49: Micro-Annex-UX R11.1, 8 async ports
The script file does not contain the IP address of the unit; this
allows you to transfer the file from one unit to another.
However, you must be careful if you have specified IP
addresses specified for the ports; they will be copied to the
new unit. Remember that you cannot have the same IP
addresses across different units; IP addresses must be unique.
allows you to transfer the file from one unit to another.
However, you must be careful if you have specified IP
addresses specified for the ports; they will be copied to the
new unit. Remember that you cannot have the same IP
addresses across different units; IP addresses must be unique.