Intermec 1470 Mode D'Emploi
Introduction and Installation
1-7
1
3. Connect the appropriate interface cable to the imager and to the terminal/computer.
1
2
3
4
4. Connect the power supply (4 to 9V). The imager beeps twice.
5. Turn the terminal/computer power back on.
6. Verify the imager operation by scanning a bar code. The imager beeps once.
The imager is now connected and ready to communicate with your terminal/PC. You
must program the imager for your interface before bar code data can be transmitted to
your terminal/PC. If you are using the imager as a keyboard wedge, see “Terminal
Interface” in Chapter 3. If the imager is connected via a serial port, see “Connecting the
Imager to a Serial Port” in the next section.
must program the imager for your interface before bar code data can be transmitted to
your terminal/PC. If you are using the imager as a keyboard wedge, see “Terminal
Interface” in Chapter 3. If the imager is connected via a serial port, see “Connecting the
Imager to a Serial Port” in the next section.
Connecting the Imager to a Serial Port
1. Turn off power to the terminal/computer.
2. Connect the interface cable to the imager.
3. Connect the interface cable to the power supply (4 to 9V) and plug in the power
supply. The imager beeps twice.
4. Connect the interface cable to the terminal/computer.