Bosch nem7522uc Manuel De Montage

English 4

 To avoid electrical shock hazard, before installing the 

cooktop, switch power off at the service panel and lock the panel to 
prevent the power from being switched on accidentally.

A foam tape is provided to seal the cooktop edges to the countertop. Turn cooktop 
upside down and apply tape approximately 1/16” (1.6 mm) from the glass edges. 
Use tape around the entire glass perimeter. Cut off excess tape where tape ends 
butt.

Cut out the countertop per the dimensions shown in Table 1 Countertop Cutout 
Dimensions. Always consult the countertop manufacturer for specific instruc-
tions. 

Countertops made from natural (i.e. granite and marble) or SOLID SURFACE 
MATERIALS, such as Surell™ and Corian®, require special cutout preparation 
and installation procedures. Follow the guidelines below for preparing the cutout 
for solid surfaces.

1. Round the cutout corners according to instructions from the countertop manu-

facturer.

2. Apply heat reflective tape (such as Scotch® Aluminum Foil Tape #425 or 

#427) around the cutout so that it folds over the top and side surfaces. Be 
sure the tape extends beyond the outermost flange of the cooktop. All corners 
should also be covered with tape.

3. Attach brackets to the burner box using washers and screws provided. Use a 

wooden block underneath the countertop before tightening the bracket 
screws.

4. Center cooktop in the cutout to ensure adequate clearance between the 

burner box and countertop edge. (A light pencil mark along the center of front 
edge and side edge of cooktop and counter will aid in the positioning of the 
cooktop in the center.)

5. Trim excess aluminum tape from along the frame edges. BE CAREFUL not to 

scratch the countertop.

Foam 

Tape 

Seal

Swivel Conduit Connector

shows location of
aluminum reflective 
tape

tape top and vertical 
sides of cutout