3com S7906E Manuel De Montage
1-6
Configuring the Monitor Port for the Local Mirroring Group
You can configure the monitor port for a mirroring group in system view, or assign the current port to a
mirroring group as the monitor port in interface view. The two modes lead to the same result.
Configuring the monitor port in system view
Follow these steps to configure the monitor port of a local mirroring group in system view:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Configure the monitor port
mirroring-group group-id
monitor-port monitor-port-id
monitor-port monitor-port-id
Required
By default, no monitor port is
configured for a mirroring
group.
configured for a mirroring
group.
Configuring the monitor port in interface view
Follow these steps to configure the monitor port of a local mirroring group in interface view:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
interface-number
—
Configure the current port as
the monitor port
the monitor port
[ mirroring-group group-id ]
monitor-port
monitor-port
Required
By default, a port does not
serve as the monitor port for
any mirroring group.
serve as the monitor port for
any mirroring group.
z
A mirroring group contains only one monitor port.
z
To ensure that the port mirroring function works properly, do not enable STP, MSTP, or RSTP on
the monitor port.
z
You are recommended to use a monitor port only for port mirroring. This is to ensure that the data
monitoring device receives and analyzes only the mirrored traffic rather than a mix of mirrored
traffic and normally forwarded traffic.
z
A port connected to an RRPP ring cannot be configured as the monitor port of a port mirroring
group.