3com S7906E Manuel De Montage
1-28
Configuration Prerequisites
z
Configure IP addresses for interfaces (such as the VLAN interface, and loopback interface) on the
device to ensure normal communication.
z
Specify one of the above interfaces as the source interface of the tunnel.
z
Ensure reachability between the tunnel source and destination addresses.
Configuration Procedure
Follow these steps to configure an IPv4 over IPv6 tunnel:
To do…
Use the command…
Remarks
Enter system view
system-view
—
Enable IPv6
ipv6
Required
By default, the IPv6 packet
forwarding function is disabled.
forwarding function is disabled.
Enter tunnel interface view interface tunnel number
—
Configure an IPv4 address
for the tunnel interface
for the tunnel interface
ip address ip-address { mask
| mask-length } [ sub ]
| mask-length } [ sub ]
Required
By default, no IPv4 address is
configured for the tunnel interface.
configured for the tunnel interface.
Specify the IPv4 over IPv6
tunnel mode
tunnel mode
tunnel-protocol ipv4-ipv6
Optional
By default, the tunnel is a GRE over
IPv4 tunnel. The same tunnel mode
should be configured at both ends of
the tunnel. Otherwise, packet
delivery will fail.
IPv4 tunnel. The same tunnel mode
should be configured at both ends of
the tunnel. Otherwise, packet
delivery will fail.
Configure the source
address or interface for the
tunnel interface
address or interface for the
tunnel interface
source { ipv6-address |
interface-type
interface-number }
interface-type
interface-number }
Required
By default, no source address or
interface is configured for the tunnel.
interface is configured for the tunnel.
Configure the destination
address for the tunnel
interface
address for the tunnel
interface
destination ipv6-address
Required
By default, no destination address is
configured for the tunnel.
configured for the tunnel.