3com S7906E Manuel De Montage

1-35

Configuration on Switch A

# Enable IPv6.

<SwitchA> system-view

[SwitchA] ipv6

# Configure an IPv6 address for VLAN-interface 100.

[SwitchA] interface vlan-interface 100

[SwitchA-Vlan-interface100] ipv6 address 2002:1::1 64

[SwitchA-Vlan-interface100] quit

# Configure an IPv6 address for VLAN-interface 101 (the physical interface of the tunnel).

[SwitchA] interface vlan-interface 101

[SwitchA-Vlan-interface101] ipv6 address 2002::11:1 64

[SwitchA-Vlan-interface101] quit

# Create the interface tunnel 1.

[SwitchA] interface tunnel 1

# Configure an IPv6 address for the interface tunnel 1.

[SwitchA-Tunnel1] ipv6 address 3001::1:1 64

# Configure the tunnel encapsulation mode.

[SwitchA-Tunnel1] tunnel-protocol ipv6-ipv6

# Configure the source address for the interface tunnel 1 (IP address of VLAN-interface 101).

[SwitchA-Tunnel1] source 2002:11::1

# Configure the destination address for the interface tunnel 1 (IP address of VLAN-interface 101 of

Switch B).

[SwitchA-Tunnel1] destination 2002::22:1

[SwitchA-Tunnel1] quit

# Create service loopback group 1 to support the tunnel service.

[SwitchA] service-loopback group 1 type tunnel

# Add GigabitEthernet 2/0/3 to service loopback group 1.

[SwitchA] interface GigabitEthernet 2/0/3

[SwitchA-GigabitEthernet2/0/3] undo stp enable

[SwitchA-GigabitEthernet2/0/3] port service-loopback group 1

[SwitchA-GigabitEthernet2/0/3] quit

# Reference service loopback group 1 on the tunnel.

[SwitchA] interface tunnel 1

[SwitchA-Tunnel1] service-loopback-group 1

[SwitchA-Tunnel1] quit

# Configure a static route from Switch A through the interface tunnel 1 to Group 2.

[SwitchA] ipv6 route-static 2002:3:: 64 tunnel 1

Configuration on Switch B

# Enable IPv6.

<SwitchB> system-view