3com S7906E Guide De Référence
1-8
Default Level
1: Monitor level
Parameters
verbose: Displays detailed routing table information, including both active and inactive routes. With this
argument absent, the command displays brief information about active IPv6 MBGP routes only.
Description
Use the display ipv6 multicast routing-table command to display the IPv6 MBGP routing table.
There are active and inactive routes in the IPv6 MBGP routing table. Active routes are the optimal
routes used for RPF check.
Examples
# Display brief IPv6 MBGP routing table information.
<Sysname> display ipv6 multicast routing-table
Routing Table :
Destinations : 1 Routes : 1
Destination : ::1 PrefixLength : 128
NextHop : ::1 Preference : 0
Interface : InLoopBack0 Protocol : Direct
State : Active NoAdv Cost : 0
Tunnel ID : 0x0 Label : NULL
Age : 156sec
Table 1-1 display ipv6 multicast routing-table command output description
Field
Description
Destination
Destination IPv6 address
PrefixLength Prefix
length of the address
Nexthop
Next hop IP address
Preference Route
preference
Interface Outbound
interface
Protocol Routing
protocol
State
Status of the route, which could be Active, Inactive, Adv, or NoAdv
Cost Route
cost
Tunnel ID
Tunnel ID
Label Label
Age
Time elapsed since the route was generated
# Display detailed IPv6 MBGP routing table information.
<Sysname> display ipv6 multicast routing-table verbose
Routing Table :