3com S7906E Guide De Référence

 

1-16 

# Assign the trunk port GigabitEthernet 2/0/1 to VLAN 2, VLAN 4, and VLAN 50 through VLAN 100. 

<Sysname> system-view 

[Sysname] interface GigabitEthernet 2/0/1 

[Sysname-GigabitEthernet2/0/1] port link-type trunk 

[Sysname-GigabitEthernet2/0/1] port trunk permit vlan 2 4 50 to 100 

Please wait........... Done.  

# Assign the trunk Layer-2 aggregate interface Bridge-aggregation 1 to VLAN 2, assuming that 

Bridge-aggregation 1 does not have member ports.  

<Sysname> system-view 

[Sysname] interface bridge-aggregation 1 

[Sysname-Bridge-Aggregation1] port trunk permit vlan 2 

Please wait... Done. 

# Assign the trunk Layer-2 aggregate interface Bridge-aggregation 1 to VLAN 13 and VLAN 15. 

Among the member ports of the aggregation group corresponding to Bridge-aggregation 1, 

GigabitEthernet 2/0/1 is an access port, and GigabitEthernet 2/0/2 is a trunk port.  

<Sysname> system-view 

[Sysname] interface bridge-aggregation 1 

[Sysname-Bridge-Aggregation1] port trunk permit vlan 13 15 

 Please wait... Done. 

  Error: Failed to configure on interface GigabitEthernet2/0/1! This port is not a Trunk port! 

 Configuring GigabitEthernet2/0/1... Done. 

Among the output fields above, the message “Please wait... Done” indicates that the configuration on 

Bridge-aggregation 1 succeeded; “Error: Failed to configure on interface GigabitEthernet2/0/1! This 

port is not a Trunk port!” indicates that the configuration failed on GigabitEthernet 2/0/1 because 

GigabitEthernet 2/0/1 was not a trunk port; “Configuring Ethernet GigabitEthernet 2/0/2... Done” 

indicates that the configuration on GigabitEthernet 2/0/2 succeeded.  

port trunk pvid vlan vlan-id 

undo port trunk pvid 

Ethernet interface view, port group view, Layer-2 aggregate interface view 

2: System level 

vlan-id: VLAN ID, in the range of 1 to 4094 

Use the port trunk pvid vlan command to configure the default VLAN ID for the trunk port.