3com S7906E Guide De Référence

 

1-4 

2: System level 

dynamic: Dynamic MAC address entries. Aging time is set for these entries. 

static: Static MAC address entries. They do not age but you can add or remove them. 

mac-address: Specifies a MAC address in the format of H-H-H, where 0s at the beginning of each H 

(16-bit hexadecimal digit) can be omitted; for example, inputting “f-e2-1” indicates that the MAC address 

is “000f-00e2-0001”. 

vlan vlan-id: Specifies an existing VLAN to which the Ethernet interface belongs, where vlan-id is the 

specified VLAN ID, in the range 1 to 4094.  

Use the mac-address command to add or modify a MAC address entry on a specified Ethernet port. 

Use the undo mac-address command to remove a MAC address entry on the Ethernet port. 

Note that: 

z 

As your MAC address entries configuration cannot survive a reboot, save it after completing the 

configuration. The dynamic MAC address table entries however will be lost whether you save the 

configuration or not. 

z 

You cannot configure a static or dynamic MAC address entry on an aggregation port. 

Related commands: display mac-address. 

# Add a static entry for MAC address 00e0-fc01-0101 on port GigabitEthernet 2/0/1 which belongs to 

VLAN 2. 

<Sysname> system-view 

[Sysname] interface gigabitethernet 2/0/1 

[Sysname-GigabitEthernet2/0/1] mac-address static 00e0-fc01-0101 vlan 2 

mac-address blackhole mac-address vlan vlan-id 

mac-address { dynamic | static } mac-address interface interface-type interface-number vlan vlan-id 

undo mac-address [ { dynamic | static } mac-address interface interface-type interface-number vlan 

vlan-id ] 

undo mac-address [ blackhole | dynamic | static ] [ mac-address ] vlan vlan-id  

undo mac-address [ dynamic | static ] mac-address interface interface-type interface-number vlan 

vlan-id 

undo mac-address [ dynamic | static ] interface interface-type interface-number 

System view