3com S7906E Guide De Référence

 

1-14 

# Add virtual IP address 10.10.10.11 to VRRP group 1. 

[Sysname-Vlan-interface2] vrrp vrid 1 virtual-ip 10.10.10.11 

display vrrp ipv6 [ verbose ] [ interface interface-type interface-number [ vrid virtual-router-id ] ]  

Any view 

1: Monitor level 

verbose: Displays detailed state information of VRRP. 

interface interface-type interface-number: Displays VRRP state information of the specified interface. 

interface-type interface-number specifies an interface by its type and number. 

vrid virtual-router-id: Displays state information of the specified VRRP group. virtual-router-id specifies 

a VRRP group by its group number, in the range 1 to 255. 

Use the display vrrp ipv6 command to display the state information of VRRP for IPv6. 

If you do not specify verbose, only the brief state information of VRRP is displayed. 

If you specify both an interface and a VRRP group, only the state information of the specified VRRP 

group is displayed; if you only specify an interface, the state information of all the VRRP groups on the 

interface is displayed; if you specify neither, the state information of all the VRRP groups on the device 

is displayed. 

# Display brief information about all VRRP groups on the device for IPv6. 

<Sysname> display vrrp ipv6 

 IPv6 Standby Information: 

 Run Method      : VIRTUAL-MAC 

 Virtual IP Ping : Enable 

 Total number of virtual routers: 1 

 Interface          VRID  State       Run     Adver.  Auth     Virtual 

                                      Pri     Time    Type        IP 

 --------------------------------------------------------------------- 

 Vlan100             1    Master      100     100     NONE     FE80::1 

# Display detailed information about all VRRP groups on the device. 

<Sysname> display vrrp ipv6 verbose 

 IPv6 Standby Information: 

 Run Method      : VIRTUAL-MAC