3com S7906E Guide De Référence

 

1-1 

display garp statistics [ interface interface-list ] 

Any view 

1: Monitor level 

interface  interface-list: Defines one or multiple Ethernet ports for which the GARP statistics will be 

displayed. You can provide up to 10 Ethernet port lists, by each of which you can specify an individual 

port in the form of interface-type interface-number, or a port range in the form of interface-type 

interface-number1  to  interface-type interface-number2, where the end-port number specified by 

interface-number2 must be greater than the start-port number specified by interface-number1. If no 

ports are specified, this command displays the GARP statistics for all ports. 

Use the display garp statistics command to display the GARP statistics of the specified port(s) or all 

ports if no ports are specified.  

This command displays the statistics about GVRP packets received, transmitted, and dropped on 

GVRP-enabled ports. When the system is restarted or after you perform the reset garp statistics 

command, the existing packet statistics are cleared and the system starts to collect new GARP statistics. 

With the statistics, you can judge whether a GVRP-enabled port is operating normally. 

z 

If the number of received and transmitted GVRP packets on the port is the same as that on the 

remote port, it indicates that the two ends are transmitting and receiving GVRP packets normally 

and no registration information is lost.  

z 

If there are dropped GVRP packets on the port, check its registration mode. GVRP packets are 

likely to be dropped if the registration mode is fixed or forbidden, because dynamic VLANs cannot 

be registered in either of the modes.  

# Display statistics about GARP for port GigabitEthernet 2/0/1.  

<Sysname> display garp statistics interface GigabitEthernet2/0/1 

        GARP statistics on port GigabitEthernet2/0/1