3com S7906E Guide De Référence

 

1-25 

Use the rip summary-address command to configure RIPv2 to advertise a summary route through the 

interface. 

Use the undo rip summary-address command to remove the configuration. 

Note that the summary address is valid only when the automatic summarization is disabled. 

Related commands: summary. 

# Advertise a local summary address on VLAN-interface 10.  

<Sysname> system-view 

[Sysname] interface vlan-interface 10 

[Sysname-Vlan-interface10] rip summary-address 10.0.0.0 255.255.255.0 

rip version { 1 | 2 [ broadcast | multicast ] } 

undo rip version 

Interface view 

2: System level 

1: RIP version 1.  

2: RIP version 2.  

broadcast: Sends RIPv2 messages in broadcast mode.  

multicast: Sends RIPv2 messages in multicast mode. 

Use the rip version command to specify a RIP version for the interface. 

Use the undo rip version command to remove the specified RIP version. 

By default, no RIP version is configured for an interface, which uses the global RIP version. If the global 

RIP version is not configured, the interface can only send RIPv1 broadcasts and can receive RIPv1 

broadcasts and unicasts, and RIPv2 broadcasts, multicasts and unicasts.  

If RIPv2 is specified with no sending mode configured, RIPv2 messages will be sent in multicast mode. 

When RIPv1 runs on an interface, the interface will: 

z 

Send RIPv1 broadcast messages 

z 

Receive RIPv1 broadcast messages 

z 

Receive RIPv1 unicast messages 

When RIPv2 runs on the interface in broadcast mode, the interface will: