3com S7906E Guide De Référence

 

1-29 

2: System level 

None 

Use the validate-source-address command to enable the source IP address validation on incoming 

RIP routing updates. 

Use the undo validate-source-address command to disable the source IP address validation. 

The source IP address validation is enabled by default. 

Generally, disabling the validation is not recommended. 

# Enable the source IP address validation on incoming messages. 

<Sysname> system-view 

[Sysname-rip] rip 100 

[Sysname-rip-100] validate-source-address 

version { 1 | 2 } 

undo version 

RIP view 

2: System level 

1: Specifies the RIP version as RIPv1. 

2: Specifies the RIP version as RIPv2. RIPv2 messages are multicast. 

Use the version command to specify a global RIP version. 

Use the undo version command to remove the configured global RIP version. 

By default, if an interface has a RIP version specified, the RIP version takes effect; if it has no RIP 

version specified, it can send RIPv1 broadcasts, and receive RIPv1 broadcasts, RIPv1 unicasts, RIPv2 

broadcasts, RIPv2 multicasts, and RIPv2 unicasts.   

Note that: 

z 

If an interface has an RIP version specified, the RIP version takes precedence over the global RIP 

version.