3com S7906E Guide De Référence

 

1-43 

[Sysname-ospf-100] maximum-routes intra 500 

network ip-address wildcard-mask 

undo network ip-address wildcard-mask 

OSPF area view 

2: System level 

ip-address: IP address of a network. 

wildcard-mask: Wildcard mask of the IP address. For example, the wildcard mask of mask 255.0.0.0 is 

0.255.255.255. 

Use the network command to enable OSPF on the interface attached to the specified network in the 

area. 

Use the undo network command to disable OSPF for the interface attached to the specified network in 

the area. 

By default, an interface neither belongs to any area nor runs OSPF. 

You can configure one or multiple interfaces in an area to run OSPF. Note that the interface’s primary IP 

address must fall into the specified network segment to make the interface run OSPF. If only the 

interface’s secondary IP address falls into the network segment, the interface cannot run OSPF. 

Related commands: ospf. 

# Specify the interface whose primary IP address falls into 131.108.20.0/24 to run OSPF in Area 2. 

<Sysname> system-view 

[Sysname] ospf 100 

[Sysname-ospf-100] area 2 

[Sysname-ospf-100-area-0.0.0.2] network 131.108.20.0 0.0.0.255 

nssa [ default-route-advertise | no-import-route | no-summary ] * 

OSPF area view