3com S7906E Guide De Référence

 

1-51 

z 

When the network type of an interface is NBMA, you need to use the peer command to specify a 

neighbor. 

z 

If only two routers run OSPF on a network segment, you can configure associated interfaces’ 

network type as P2P.  

Related commands: ospf dr-priority. 

 

This command is not supported on the null or loopback interfaces. 

 

# Configure the interface’s network type as NBMA. 

<Sysname> system-view 

[Sysname] interface vlan-interface 10 

[Sysname-Vlan-interface10] ospf network-type nbma 

System view 

None 

Use the ospf packet-process prioritized-treatment command to enable OSPF to give priority to 

receiving and processing Hello packets. 

Use the undo ospf packet-process prioritized-treatment command to restore the default. 

By default, this function is not enabled.  

# Enable OSPF to give priority to receiving and processing Hello packets. 

<Sysname> system-view 

[Sysname] ospf packet-process prioritized-treatment 

ospf timer dead seconds