3com S7906E Guide De Référence
1-7
Description
Use the display interface command to display the current state of a specified interface and related
information.
z
If neither interface type nor interface number is specified, all interface information will be displayed.
z
If only interface type is specified, then only information of this particular type of interface will be
displayed.
z
If both interface type and interface number are specified, then only information of the specified
interface will be displayed.
Related commands: interface.
Examples
# Display the current state of Layer 2 interface Ethernet 2/0/1 and related information.
<Sysname> display interface ethernet 2/0/1
Ethernet2/0/1 current state: DOWN
IP Packet Frame Type: PKTFMT_ETHNT_2, Hardware Address: 000f-e200-8048
Description: Ethernet2/0/1 Interface
Loopback is not set
Media type is twisted pair, port hardware type is 100_BASE_TX
Unknown-speed mode, unknown-duplex mode
Link speed type is autonegotiation, link duplex type is autonegotiation
Flow-control is not enabled
The Maximum Frame Length is 9022
Broadcast MAX-ratio: 100%
Unicast MAX-ratio: 100%
Multicast MAX-ratio: 100%
Allow jumbo frame to pass
PVID: 100
Mdi type: auto
Link delay is 10(sec)
Port link-type: access
Tagged VLAN ID : none
Untagged VLAN ID : 100
Port priority: 0
Last 300 seconds input: 0 packets/sec 0 bytes/sec -%
Last 300 seconds output: 0 packets/sec 0 bytes/sec -%
Input (total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts
Input (normal): 0 packets, - bytes
0 broadcasts, 0 multicasts
Input: 0 input errors, 0 runts, 0 giants, 0 throttles
0 CRC, 0 frame, - overruns, 0 aborts
- ignored, - parity errors
Output (total): 0 packets, 0 bytes
0 broadcasts, 0 multicasts, 0 pauses
Output (normal): 0 packets, - bytes
0 broadcasts, 0 multicasts, 0 pauses
Output: 0 output errors, - underruns, - buffer failures