3com S7906E Guide De Référence

 

1-28 

IGMP-Snooping view 

2: System level 

interval: Dynamic router port aging time, in seconds. The effective range is 1 to 1,000.  

Use the router-aging-time command to configure the aging time of dynamic router ports globally.  

Use the undo router-aging-time command to restore the default setting.  

By default, the aging time of dynamic router ports is 105 seconds.  

This command works only on IGMP Snooping–enabled VLANs, but not on VLANs with IGMP enabled 

on their VLAN interfaces.  

Related commands: igmp-snooping router-aging-time.  

# Set the aging time of dynamic router ports globally to 100 seconds.  

<Sysname> system-view 

[Sysname] igmp-snooping 

[Sysname-igmp-snooping] router-aging-time 100 

source-deny port interface-list 

undo source-deny port interface-list 

IGMP-Snooping view 

2: System level 

interface-list: Specifies one or multiple ports. You can provide up to ten port lists, by each of which you 

can specify an individual port in the form of interface-type interface-number, or a port range in the form 

of  interface-type start-interface-number  to  interface-type end-interface-number, where the end 

interface number must be greater than the start interface number.  

Use the source-deny  command to enable multicast source port filtering so that all multicast data 

packets are blocked.  

Use the undo source-deny command to disable multicast source port filtering.