Xanté aw 1200 Mode D'Emploi
XANTÉ Utilities: Macintosh and PC – 5-9
3.
Check and change the following settings accordingly if necessary (fig. 5.10). See
“TCP/IP Addresses” in chapter 4 for setting details.
“TCP/IP Addresses” in chapter 4 for setting details.
a.
Change the TCP/IP address Network Class if necessary (check with your
System Supervisor); then, click Change.
System Supervisor); then, click Change.
b.
Change the printer’s default TCP/IP address (Network and Node IDs) to
the address assigned by your System Supervisor using the scroll arrows
beside each number; then, click Change.
the address assigned by your System Supervisor using the scroll arrows
beside each number; then, click Change.
c.
Change the Subnet Mask if necessary; then, click Change. If you are using
DHCP, continue to step 4.d; otherwise skip to step 5.
DHCP, continue to step 4.d; otherwise skip to step 5.
d.
Select either DHCP On or DHCP Off and click Change.
4.
Close your browser; then, restart your printer to make the new TCP/IP address
take effect.
take effect.
Informational Pages (Start Page and Low Toner Page)
The Information Pages window allows you enable or disable printing of the start-up
page or the low toner page.
page or the low toner page.
1.
Go to the printer home page (fig. 5.7). See “Printer Home Page” earlier in this
chapter for details.
chapter for details.
2.
Select Printer Configuration: Informational Pages. The Informational Pages
window appears (fig. 5.11).
window appears (fig. 5.11).
Fig. 5.11 Informational Pages Window
3.
Set startup page and low toner page printing as desired (fig. 5.11).
a.
Start Page: Select either On to enable startup page printing or select Off
to disable it. Then, click Change.
to disable it. Then, click Change.