Xanté aw 1200 Mode D'Emploi
Introduction and Installation – 1-21
Connecting
1.
Turn off your printer and PC.
2.
Plug the cable’s 36-pin connector into the printer’s parallel port (fig. 1.41) and
the 25-pin connector into the computer’s parallel port.
the 25-pin connector into the computer’s parallel port.
3.
Turn on your printer and computer.
4.
Verify that the printer’s parallel interface is enabled and configured for ECP or
bi-directional parallel port mode in your computer setup (i.e. BIOS or CMOS).
See your computer documentation for how to access your BIOS/CMOS setup.
bi-directional parallel port mode in your computer setup (i.e. BIOS or CMOS).
See your computer documentation for how to access your BIOS/CMOS setup.
Before using your printer, install and configure the Adobe PostScript printer driver
and your printer’s PPD. See chapter 3 for details.
and your printer’s PPD. See chapter 3 for details.
Connecting to the Ethernet Port
The following sections cover connecting via the Ethernet port.
Required Equipment
Use a CAT 5 Ethernet cable with RJ45 connectors.
RJ-45
Connector
Ethernet Port
Fig. 1.42 Connect to Ethernet Port
You can connect two Ethernet devices together, bypassing a hub, using a crossover/
patch cable where pin 1 is crossed to pin 3 and pin 2 is crossed to pin 6.
patch cable where pin 1 is crossed to pin 3 and pin 2 is crossed to pin 6.
Connecting
1.
Turn off the printer.
2.
Connect the printer to the appropriate port for the cable used on your network
(figs. 1.42).
(figs. 1.42).