Gestetner 1045 Mode D'Emploi
Windows 2000 Configuration
18
2
Installing SmartNetMonitor for Client
Follow the procedure below to install SmartNetMonitor for Client.
A
Configure the IP parameters on the Network Interface Board using the op-
eration panel.
eration panel.
Reference
For more information about setting IP parameters, see “Configuring the
printer for the Network with the Operation Panel” in the System Settings.
For more information about setting IP parameters, see “Configuring the
printer for the Network with the Operation Panel” in the System Settings.
B
Insert the CD-ROM labeled “Printer Drivers and Utilities” into the CD-
ROM drive.
ROM drive.
Note
❒ If the installer starts automatically, you can use it to install SmartNetMon-
itor for Client. Follow the instructions on the screen.
C
Open [Control Panel], and double-click the [Add/Remove Programs] icon.
D
Click [Add New Programs], and then click [CD or Floppy].
E
Click [Next >].
F
Type the name of the CD-ROM drive in the [Open] box, followed by “:\
NETWORK \ NETMON \ CLIENT \ DISK1 \ SETUP.EXE” (do not in-
clude the quotation marks), and then click [Finish].
NETWORK \ NETMON \ CLIENT \ DISK1 \ SETUP.EXE” (do not in-
clude the quotation marks), and then click [Finish].
Note
❒ An example would be “D:\ NETWORK \ NETMON \ CLIENT \ DISK1
\ SETUP.EXE” when the CD-ROM drive letter is “D”.
G
From the [Choose Setup Language] list, select the language you want to use,
and then click [OK].
and then click [OK].
H
After the [Welcome] dialog box appears, click [Next >].
Follow the instructions on the screen.
After the installation is complete, configure the printer port with SmartNet-
Monitor for Client.
Follow the instructions on the screen.
After the installation is complete, configure the printer port with SmartNet-
Monitor for Client.
Note
❒ If the dialog box asking if you want to restart the computer appears, select
[Yes, I want to restart my computer now.]
.