Gestetner 5450 Guide D’Exploitation
48
Installation
The following section describes procedures to remove
the controller’s top cover and insert a SIMM board.
the controller’s top cover and insert a SIMM board.
Warning
Hazardous voltages are present in the printer
controller. Never remove any cover or work
near exposed electrical parts while the power
cord is connected.
controller. Never remove any cover or work
near exposed electrical parts while the power
cord is connected.
Accessing the SIMM Slots.
1. Switch the controller OFF
2. Unplug the power cord from the controller.
3. Position the controller so the right side is facing
2. Unplug the power cord from the controller.
3. Position the controller so the right side is facing
you.
4. Place the antistatic bag containing the SIMM
board(s) near the controller.
5. Use a Phillips #2 screwdriver to remove the four
screws holding the top cover to the chassis.
Figure B-1.3. Removing top cover hold-down
screws.