Gestetner dsc224 Mode D'Emploi

Appendix

112

Use the route command to control the routing table.
This command allows you to configure and display routing information. You
can change the network configuration from remote PCs using this command.

❒ The maximum number of routing tables are 16.

*1

IP address

Use this command to configure SLP settings.
You can search the NetWare server using SLP in the PureIP environment of
NetWare5/5.1. To use the slp command, you can configure the value of TTL
which can be used by the SLP multi-cast-packet.

❒ The default value of TTL is “1”. A search is executed only within a local seg-

ment. If the router does not support multi-cast, the settings are not available
even if the TTL value is increased.

❒ The acceptable TTL value is 1 - 255.

Use the wiconfig command to configure the IEEE 802.11b settings.

❒ You can make settings when installing the optional 802.11b Interface Kit.

route add {host | net} desti-
nation 

 gateway 

Adds a host/network route to “destination”, and a gateway ad-
dress to “gateway” in the table. Host becomes the default setting.

route delete {host | net} 
destination 

Deletes a host/network route from the table. Host becomes the 
default setting.

route get {destination 

}

Displays only route information corresponding to a specified 
destination. When the destination is unspecified, all routing in-
formation is displayed.

route active {host | net} des-
tination 

 on/off

You can turn the specified destination on or off. Host becomes 
the default setting.

route add default gateway 

You can set the default gateway address.

route flush

Deletes all routing information.