Gestetner dsc224 Mode D'Emploi
Remote Maintenance by telnet
113
7
❖
❖
❖
❖ View settings
The following command displays the current IEEE 802.11b settings.
msh> wiconfig
The IEEE 802.11b card information is displayed.
The IEEE 802.11b card information is displayed.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is not working correctly, the IEEE 802.11b card
information is not displayed.
❖
❖
❖
❖ Configuration
Parameter
Value to be configured
mode [ap|802.11adhoc|adhoc]
You can set infrastructure mode (ap), 802.11
ad hoc mode (802.11adhoc) or ad hoc mode
(adhoc).
ad hoc mode (802.11adhoc) or ad hoc mode
(adhoc).
The default is 802.11 ad hoc mode.
ssid ID value
You can set for SSID in infrastructure mode.
The characters that can be used are ASCII
0x20-0x7e (32 bytes).
A SSID value is set automatically to the near-
est access point if the setting has not been
made.
0x20-0x7e (32 bytes).
A SSID value is set automatically to the near-
est access point if the setting has not been
made.
If the setting has not been made for ad hoc
mode, the same value as for infrastructure
mode or an “ASSID” value is set automati-
cally if the setting has not been made.
mode, the same value as for infrastructure
mode or an “ASSID” value is set automati-
cally if the setting has not been made.
channel frequency channel no.
You can set the channel.
You can specify from following channel.
• Metric Version :1-13
• Inch Version :1-11
Set the same channel for all the machines you
are using.
are using.
enc [on|off]
You can enable or disable the WEP function.
To enable the WEP function, specify [on]; to
disable it, specify [off].
To enable the WEP function, specify [on]; to
disable it, specify [off].
To start the WEP function, enter the correct
WEP key.
WEP key.
key [key value]
64-bit or 128-bit can be set.
Only 10 hexadecimal characters can be set
when using 64-bit or 26 hexadecimal charac-
ters when using 128-bit.
when using 64-bit or 26 hexadecimal charac-
ters when using 128-bit.
Also, set 0x as prefix.
To use this function, set the same WEP key
for all the ports that transmit to each other.
for all the ports that transmit to each other.