Gestetner dsc224 Mode D’Emploi
If You Cannot Make Copies as You Want
89
4
In Image Repeat mode, the
original image is not cop-
ied repeatedly.
original image is not cop-
ied repeatedly.
You selected copy paper
the same size as the origi-
nals, or you did not select
the proper reproduction
ratio.
the same size as the origi-
nals, or you did not select
the proper reproduction
ratio.
Select copy paper larger than the
originals.
originals.
Select the proper reproduction ratio.
The stamp position is
wrong.
wrong.
The paper orientation is
wrong.
wrong.
Check the paper orientation and
stamp position.
stamp position.
When Combine, parts of
the image are not copied.
the image are not copied.
You specified a reproduc-
tion ratio that does not
match the sizes of your
originals and copy paper.
tion ratio that does not
match the sizes of your
originals and copy paper.
When you specify a reproduction
ratio using Manual Paper Select
mode, make sure that the ratio
matches your originals and the copy
paper.
ratio using Manual Paper Select
mode, make sure that the ratio
matches your originals and the copy
paper.
Note
❒ Select the correct reproduction
ratio before using Combine
mode.
mode.
Order of copies is not cor-
rect.
rect.
You placed the originals in
the incorrect order.
the incorrect order.
When placing a stack of originals in
the document feeder, the last page
should be on the bottom.
the document feeder, the last page
should be on the bottom.
If you place an original on the expo-
sure glass, start with the first page to
be copied.
sure glass, start with the first page to
be copied.
When Duplex, copy is
made Top/Bottom even
though Left/Right is se-
lected.
made Top/Bottom even
though Left/Right is se-
lected.
You placed the originals in
the wrong direction.
the wrong direction.
Place the originals in the correct ori-
entation.
entation.
⇒ p.12 “Original Orienta-
tion”
Paper does not output dur-
ing printing with stapling.
ing printing with stapling.
When you stop printing
while using the staple func-
tion, papers not stapled
during printing may be left
in the staple unit.
while using the staple func-
tion, papers not stapled
during printing may be left
in the staple unit.
Press the
{{{{Reset}}}} key and cancel
copy settings, including stapling.
Colors changed even
though they were not se-
lected.
though they were not se-
lected.
If color range is set to
“Wider” and if red is select-
ed, colors such as magenta
and orange may change.
“Wider” and if red is select-
ed, colors such as magenta
and orange may change.
Adjust the color range by setting the
color width.
color width.
⇒ p.106 “Adjust Color
Image”
Colors not selected will be
erased when using Erase
mode.
erased when using Erase
mode.
If color range is set to
“Wider” and if red is select-
ed, colors such as magenta
and orange may change.
“Wider” and if red is select-
ed, colors such as magenta
and orange may change.
Adjust the color range by setting the
color width.
color width.
⇒ p.106 “Adjust Color
Image”
Problem
Cause
Action
UranosC1-ENcopyA_F1_FM.book Page 89 Friday, July 26, 2002 5:01 PM