Gestetner dsc332 Mode D’Emploi

Page de 1186
The Machine Does Not Print
31
4
When using wireless LAN, 
is the access point correctly 
set?
Check access point settings when in infrastructure mode. Depend-
ing on the access point, client access may be limited by MAC ad-
dress.
Also, check there are no problems in transmission between access 
point and wired clients, and between access point and wireless cli-
ents.
When using wireless LAN, 
is the LED on the wireless 
LAN card lit or blinking?
Confirm the orange LED is lit, and the green LED is lit or blinks 
during transmission.
Is the wireless LAN being 
used in ad hoc mode?
Turn the main power off and back on. See “Turning On the Pow-
er”, General Settings Guide.
Otherwise, configure [Network] in [Interface Settings] in [System Set-
tings]
. See “Setting Up the Machine on a Network”, Network 
Guide.
Did you change the option 
settings on the machine?
When using the RPCS™ printer driver on Windows 2000 and con-
necting with IEEE 1394, an error may occur if you change the op-
tion settings on the machine. In this case, follow the procedure 
below:
A Unplug the IEEE 1394 interface cables connected to the compu-
ter.
B Run the utility tool for the IEEE 1394 interface board, which is 
stored in the following path on the CD-ROM “Printer Drivers 
and Utilities”.
\UTILITY\1394\
Reference
For more information about using the utility tool for IEEE 
1394, see the README file in the same directory on the CD-
ROM.
C Restart the computer.
D Connect the computer to the machine using the IEEE 1394 in-
terface cables.
Possible Cause
Solutions