ONKYO TX-8222 Manuel D’Utilisation

19

 

With 

 (Remote Interactive), you can control your 

-compatible Onkyo CD player, RI Dock, and so on 

with the receiver’s remote controller.
•

 

• Push each plug in all the way to make a good 

connection.

• Use only dedicated 

 cables for 

 connections 

(no 

 cables are supplied with the receiver).

•

 jacks should be connected only to Onkyo 

components. Connecting them to another 
manufacturer’s component may cause the receiver to 
malfunction.

• Some components may not support all 

 functions. 

See the manuals supplied with your other Onkyo 
components for more information.

The receiver has AC outlets on its rear panel that can be 
used to connect the power cords of other components 
that you intend to use with the receiver. These 
components can then be left turned on so that they turn 
on and off as and when the receiver is turned on and set 
to Standby.

 

• Make sure that the total capacity of the components 

that you connect to the AC OUTLETS does not exceed 
the stated capacity (e.g., TOTAL 120 W).

 

• Onkyo components connected via should be 

connected directly to a wall outlet, not an AC 
OUTLETS on the receiver.

• The number of AC OUTLETS, socket type, and total 

capacity depends on the country in which you 
purchased the receiver.

• Connect the receiver’s power cord to a suitable wall 

outlet.

 

•

 

• Turning on the receiver may cause a momentary 

power surge that might interfere with other electrical 
equipment on the same circuit. If this is a problem, 
plug the receiver into a different branch circuit.

3_Connection_En 19 ページ ２００６年５月４日 木曜日 午後２時３８分