Belkin F1DD102U Guide D’Installation Rapide

This booklet is a quick guide through the basic steps needed to
install the SOHO Series KVM Switch with Audio (the KVM Switch). If
you have any problems during installation, please refer to the KVM
Switch User Manual.

You will need the following items to install the KVM Switch:

• SOHO Series KVM Switch with Audio

• One (each) USB keyboard, DVI monitor, and USB mouse

• One DVI and USB KVM cable per computer installed

• One 9V DC, 1A power supply adapter

• Optional—audio cables (3.5mm plugs) for speakers and

microphone installation

Recommended Cable Kits:

F1D9201-XX

KVM Cables for SOHO Series DVI with Audio,
USB Style

(-XX denotes the length of cable in 6, 10, and 15 feet)

CONSOLE USB
mouse/keyboard
ports

CONSOLE
DVI port

1st computer
USB mouse/keyboard
ports

2nd computer
USB mouse/keyboard
ports

2nd computer
DVI port–DVI 2

2nd computer
audio/microphone jacks

1st computer
audio/microphone jacks

1st computer
DVI port–DVI 1

CONSOLE
audio/
microphone
jacks

DC power jack

Base

Fig. 1

Fig. 3

Flash-upgrade port

USB input
ports—
devices 1
and 2

Introduction

Connecting the Video, Keyboard, and Mouse to the CONSOLE Ports and Computers on the KVM Switch

Powering up the KVM Switch

1. Power down your computers.

2. Remove the rear panel of the KVM Switch to expose the ports. (Fig. 1)

3. Connect your USB keyboard and USB mouse to the CONSOLE ports on your

KVM Switch. (Fig. 2)

4. Take the video cable that is attached to your DVI monitor and connect it to

the CONSOLE video port on your KVM Switch. (Fig. 3)

1. Connect the included 9V DC, 1A power supply adapter into an available

power outlet.

2. Attach the barrel into the power jack on the KVM Switch to power

the unit. The LEDs should illuminate. (Fig. 4)

Fig. 2

Fig. 4

Installing the KVM Switch Base