Infocus LP120 Guide De Branchement
Replacing the Lamp
Plug in the lamp power connector.
9
*009-0818-01*
Disconnect the lamp power connector from
its plug in the projector. To do this, press
down on the latch on the top of the connector,
while pulling the connector out of the plug.
its plug in the projector. To do this, press
down on the latch on the top of the connector,
while pulling the connector out of the plug.
Place the latch over the tab in the projector.
Make sure that the latch fully engages on the
tab. Then press the handle down to lock
the lamp in place.
Make sure that the latch fully engages on the
tab. Then press the handle down to lock
the lamp in place.
To remove the lamp, lift the handle upward
and slightly back to disengage the alignment
tab and fan ducting. If necessary, gently
press down on the fan ducting.
tab and fan ducting. If necessary, gently
press down on the fan ducting.
Lift the handle on the lamp to release the
latch that holds the lamp in place. Then lift
the latch off the tab inside the projector.
the latch off the tab inside the projector.
Loosen the two screws that fasten the lamp
door to the bottom of the projector.
door to the bottom of the projector.
Insert a small bladed screw driver into the pry point
and lift the lamp door off of the projector.
and lift the lamp door off of the projector.
To install the lamp, first align the tab on the
bottom of the lamp with the slot inside the
projector. Then align the duct on the rear of the
lamp with the duct inside the projector. Press the
lamp into place.
projector. Then align the duct on the rear of the
lamp with the duct inside the projector. Press the
lamp into place.
Install the lamp door, making sure to align the
connector on the lamp door with the connector
inside the projector. Tighten the two screws.
connector on the lamp door with the connector
inside the projector. Tighten the two screws.
Plug in the power cord and turn on the projector.
To reset the lamp timer, press and hold the
Volume + and Volume - keys for 10 seconds.
To reset the lamp timer, press and hold the
Volume + and Volume - keys for 10 seconds.
Press
Pull
Recessed pry point
Lamp duct
Tab
Slot
Tab
Latch
Handle
!
Before replacing the lamp, turn the power
off, and unplug the power cord. Allow the
projector to cool for 60 minutes.
off, and unplug the power cord. Allow the
projector to cool for 60 minutes.
Latch
Latch
Tab
Tab
Handle
Handle
Handle
Lock
Alignment pin
on bottom
of lamp
Fan duct