DCS DRH-48N Manuel D’Utilisation

12

Upon installation of the heater and completion of the gas line and electrical supply to each heater,
follow the steps below for  Lighting Instructions. Lighting instructions are also provided on the control
panel of the heater.

Turn gas and power to “ON”. The igniter should light within the first 4 seconds. If not, the electrode
sensor will shut off the hot surface igniter. The igniter will attempt to light 3 times before “locking out”.
During initial installation, this will happen if the gas line is not purged. To reset the control, shut off the
power to the unit and wait 5 seconds. Turn power back to “ON” position. This will allow for 3 more
lighting attempts.

1. Turn manual gas valve to “ON” position.

2. Turn electrical supply “ON”.

1. Turn electrical supply “OFF”.

2. Turn manual gas valve to “OFF” position.