Standard Horizon cpn1010i Mode D'Emploi

Page 96

Owner’s Manual

This page is used as a reference to see how well the GPS is receiving satellites.

1. Press the 

 key, tap on Navigation.

2. Tap on GPS. The GPS Status page appears. Data Boxes can be customized, except

for Latitude, Longitude and GPS Status.

The WAAS/GPS Icon Area 

 may change due to the satellite reception:

: the GPS is trying to receive a valid position fix.

: the GPS is receiving at least 2 satellites.

: the GPS is receiving at least 3 satellites.

WAAS 2D/3D : the GPS is receiving a 2D or 3D position and the correction from the WAAS satellite.

From this page it is possible to activate the GPS Setup menu

1

 following this procedure:

1.

Firstly a tap anywhere on the screen for the Soft Keys to appear is needed (they are not
displayed on the page by default and permanently). Then tapping on the 
Soft Key brings up the GPS Setup menu

1

.

 See the following table:

: Allows setting the GPS Source among Internal Antenna,  External Antenna and

Second CPN. The default setting is Internal Antenna.

: Restarts all GPS processes. Once executed, the message "Done" is shown.

: Allows setting the Navigation Speed (SOG update) among Low and High. The default

setting is High.

: Allows to resolve erratic speed readings in rough seas. Available values are Off, Low,

Medium, High. The default setting is Off.

: Allows setting what kind of Differential Correction will be used by the GPS between

WAAS/EGNOS and None. The default setting is WAAS/EGNOS.

2. Tap on the preferred item.
3. Press the 

 key to exit the menu.

1

The GPS Setup menu changes depending if the internal or external GPS is detected and switched on,
and also can be different depending on the type of the external GPS used.

From the GPS Status page it is possible to disable the WAAS/EGNOS setting following this
procedure: