Suunto mosquito Mode D'Emploi

Page de 122
71
4.3.2.  SET EAN MODE
If set to the EAN (Nitrox) mode, the correct oxygen percentage of the gas in your 
cylinder must always be entered into the computer to ensure correct nitrogen and 
oxygen calculations. Also in EAN mode, the oxygen partial pressure limit must 
be set. When in the EAN Setting mode the equivalent allowed maximum depth 
based on the chosen setting will also be displayed.
To set the EAN mode:
1.  In the Setting Mode, press S three (3) times to select the Dive Setting Mode 
(Fig. 4.7.).
2. Wait two seconds until the Dive Setting Mode activates automatically. The 
enable/disable status [On/OFF] starts to blink on the display and the selected dive 
mode (AIR, EAN or FREE) is displayed (Fig. 4.8.)
While the enable/disable status [On/OFF] is selected (blinking) press + or - to 
change the status.
3. Press S to change the selection in the following sequence:
->On/OFF status -> AIR/EAN/FREE mode-> if EAN selected: Oxygen percentage 
(O
2
%) -> Oxygen partial pressure (PO
2
)
When the dive mode is selected (blinking) press + or - to change the mode to 
EAN.
4. Press  to access the Oxygen percentage (O
2
%) and Oxygen partial pressure 
(PO
2
) settings.