Canon LV-8320 Manuel D'Instructions

Setting

Enter a Logo PIN code

Use the Point ▲▼ buttons to enter a number.

Press the Point ◄► buttons to fix the number

and move the red frame pointer to the next

box. The number changes to . If you fixed an

incorrect number, use the Point ◄► buttons

to move the pointer to the number you want to

correct, and then enter the correct number.
Repeat this step to complete entering a four-digit

number.
After entering the four-digit number, move the

pointer to

Set. Press the OK button so that you

can start to operate the projector.
If you entered an incorrect Logo PIN code,

Logo

PIN code and the number () will turn red

for a moment. Enter the correct Logo PIN code

all over again.

Logo PIN code change

Logo PIN code can be changed to your desired

four-digit number. Press the OK button to select

Logo PIN code change. Current logo PIN code

dialog box appears, use the Point ▲▼buttons to

enter the current code. The New logo PIN code

input dialog box appears. Set a new Logo PIN code,

confirmation box appears, choose

Yes to set the

new Logo PIN code.
Be sure to note the new Logo PIN code and keep it

on hand. If you lost the number, you could no longer

change the Logo PIN code setting.

Use the Point ▲▼ buttons to switch

On or Off,

and then press the OK button to make a choice.

Change the Logo PIN code lock setting

Enter a Logo PIN code

After a correct Logo PIN code

is entered, the following dialog

box appears.

CAUTION:

WHEN YOU HAVE CHANGED THE LOGO PIN

CODE, WRITE DOWN THE NEW PIN CODE

AS A REMINDER. SHOULD THE LOGO PIN

CODE BE LOST OR FORGOTTEN, THE LOGO

PIN CODE SETTING CAN NO LONGER BE

CHANGED.

Change the Logo PIN code lock setting

Change the Logo PIN code



Note:

If you forget your Logo PIN code and unable to

change it, the Logo PIN code can be reset to the

factory default setting (4321) according to the

following procedures.

When you reset the Logo PIN code, the PIN code

and Key lock will be reset, as well.

1. Unplug the AC Power Cord from the AC outlet.

2. Hold down the OK button on the projector and

connect the AC Power Cord into the outlet again.

Keep holding down the OK button until the POWER

indicator lights. The Logo PIN code returns to the

factory default setting while the Logo PIN code lock

state will remain the same as the previous set state.