Canon LV-7490 Brochure
LV-7490 Expand Serial Command Functional Specifications
23
8.5 PC Adjust Control Command
8.5.1 CF_FSYNC
Command
Command “CF_FSYNC_%1”[CR]
%1
“0000~0031” --------------- Directly select Fine Sync setting value
“UP” -------------------------- Current Fine Sync setting value + 1
“DN” -------------------------- Current Fine Sync setting value - 1
“UP” -------------------------- Current Fine Sync setting value + 1
“DN” -------------------------- Current Fine Sync setting value - 1
Details
Set Fine Sync value of PC signal
Projector does not save the value set with this command so that it resets when
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Projector does not save the value set with this command so that it resets when
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error
Code”[CR]
8.5.2 CF_TDOTS
Command
Command “CF_TDOTS_%1”[CR]
%1
“mmmm~nnnn” --- Directly select Total Dots setting value
“mmmm” shows minimum value, it is current Display Dots Horizontal value +
Position value
.
“nnnn” shows maximum value, which is not over 140MHz.
“UP” -------------- Current Total Dots setting value + 1
“DN” -------------- Current Total Dots setting value - 1
“DN” -------------- Current Total Dots setting value - 1
Details
Set Total Dots of PC signal
Projector does not save the value set with this command so that it resets when
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Projector does not save the value set with this command so that it resets when
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error
Code”[CR]
8.5.3 CF_CLAMP
Command
Command “CF_CLAMP_%1”[CR]
%1
“mmmm~nnnn” ---- Directly select Clamp setting value
“mmmm” shows minimum value, fixed-value “0001”.
“nnnn” shows maximum value: it depends on input signal.
“UP” ------------------ Current Clamp setting value + 1
“DN” ------------------ Current Clamp setting value – 1
“mmmm” shows minimum value, fixed-value “0001”.
“nnnn” shows maximum value: it depends on input signal.
“UP” ------------------ Current Clamp setting value + 1
“DN” ------------------ Current Clamp setting value – 1
Details
Set Clamp value of PC signal
Projector does not save the value set with this command so that it resets when
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Projector does not save the value set with this command so that it resets when
projector turning into Standby status or ALL is OFF.
This command is available in normal Power ON status.
Response
Acceptable “000”[CR]
Unacceptable “Error
Code”[CR]