Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch Manuel D’Utilisation

SNMP

From SNMP link under the System tab, you can configure SNMP settings for SNMP V1/V2 
and SNMPv3. 

From the SNMP link, you can access the following pages:

SNMPV1/V2 

The pages under the SNMPV1/V2 menu allow you to configure SNMP community 
information, traps, and trap flags. 

From the SNMP V1/V2 link, you can access the following pages:

Status

Operational status of the port PD detection.

Disabled - indicates no power being delivered.

DeliveringPower - indicates power is being drawn 

by device.

Fault - indicates a problem with the port.

Test - indicates port is in test mode.

otherFault - indicates port is idle due to error 

condition.

Searching - indicates port is not in one of the 

above states.

Fault Status

Describes the error description when the PSE port is 
in fault status. "No Error" value specifies that the 
PSE port is not in any error state. "MPS Absent" 
value specifies that the PSE port has detected an 
absence of main power supply. "Short" value 
specifies that the PSE port has detected a short 
circuit condition. "Overload" value specifies that the 
pd connected to the PSE port had tried to provide 
more power than it is permissible by the hardware. 
"Power Denied" value specifies that the PSE port 
has been denied power because of shortage of 
power or due to administrative action.