Xerox Phaser 5335 Mode D'Emploi

116

6 Troubleshooting

1. If paper is loaded in Tray 1 (Bypass tray), 

remove the paper and close Tray 1 (Bypass 

tray) cover.

Important
• When closing Tray 1 (Bypass tray) cover, be careful 

not to get your fingers caught between (the left or right 

edge of) the cover and the printer.

2. Gently pull the tray out of the printer.

If sheet feeders are installed, check each 

tray, starting from the bottom one to the top 

one.

Important
• Paper is fed into the printer via the front side of the 

tray. If paper is jammed in this area, you may not be 

able to pull out the tray unless you remove the trays 

below it.

• Do not pull out more than one tray at a time. 

Otherwise, the printer may topple over.

3. Clear the jammed paper and any paper that 

is wrinkled.

4. If paper is jammed in the printer, gently 

remove the paper carefully without tearing.

5. Pull the front cover release levers ("A") on 

both sides of the printer towards you and 

open the front cover.

Important
• Open the front cover even when there is no jammed 

paper in the printer. The error will not clear unless you 

open and close the front cover.