Xerox Phaser 5335 Mode D'Emploi

3.3 Printing on Transparencies 

37

This section describes how to print on transparencies.

Transparencies can be loaded in all paper trays.

Note
• For more information on how to load paper in Tray 1 (Bypass tray), refer to " Loading Paper in Tray 1 

For more information on how to load paper in the trays 2 - 5, refer to " Loading Paper in Trays 2 - 5" (P. 

„ To Load Transparencies in Tray 1 (Bypass Tray)

Important
• Transparencies for full-color printing cannot be used.

1. Fan the transparencies, and load them in 

Tray 1 (Bypass tray) with the print side 

facing down. Load only a few sheets at a 

time.

2. Adjust the paper guides to the size of the 

transparencies.

„ To Load Transparencies in Trays 2 - 5

1. Remove the paper tray from the printer, 

and adjust the paper guides to the size of 

the transparencies.

2. Load the transparencies in the tray with the 

print side facing up.

Make sure that the transparencies do not 

exceed the maximum fill-line for 

transparencies.

3. Slide the tray back into the printer.

Important
• When inserting the tray, be careful not to get your 

fingers caught between the tray and the printer or 

another tray (if the optional sheet feeders are 

installed).

4. Set the paper size dial to match the size of 

the transparencies loaded in the tray.

Note
• For information on how to change the paper type setting on the control panel, refer to " Changing the 

• You can also change the paper type setting on your print driver when requesting a print job. For more 

information, refer to "3.5 Printing by Changing the Paper Types of the Trays" (P. 44).