Xerox DocuTech 6100 Production Publisher Mode D'Emploi
Solutions in Alphabetical Order
DT6180 HandyBook 84
Clean the Pre-Fuser Sensor (Q1009)
CAUTION: The surrounding area of the machine around the sensor can be extremely hot!
To clean the Q1009 Sensor:
1. Open the right and left Processor Doors.
2. To the left of Paper Tray 1, at the back of the Fuser Module, locate the area 7 label on the machine
2. To the left of Paper Tray 1, at the back of the Fuser Module, locate the area 7 label on the machine
frame.
3. Below the label is a cutout area. Look inside the cutout area. You may need to kneel down so you
can see inside the cutout. To your left is a clear plastic bottle containing Fuser Agent. Inside the
cutout, and coming out on the side of the plastic bottle, is a shiny metal tab. The right surface near
the top of that tab is a mirror. About 10 mm (3/8 of an inch) to the right, facing the mirror, is the
Q1009 sensor. Also try following the purple and red wires, if you are having difficulties finding the
sensor.
cutout, and coming out on the side of the plastic bottle, is a shiny metal tab. The right surface near
the top of that tab is a mirror. About 10 mm (3/8 of an inch) to the right, facing the mirror, is the
Q1009 sensor. Also try following the purple and red wires, if you are having difficulties finding the
sensor.
4. Pull out the Fuser Module.
CAUTION: The Fuser may be hot!
5. Clean the mirror and sensor with a small amount of Lens and Mirror Cleaner on a soft, lint-free
cloth.