Xerox DocuTech 6100 Production Publisher Mode D'Emploi

 
DT6180 HandyBook                                                                                                                   85 

 

6.  Clean the sensor with a small amount of Lens and Mirror Cleaner on a soft, lint-free cloth.  
7.  Push the Fuser Module firmly back into the machine.  
8.  Close the Processor Doors. 

 

 
The Q861 Sensor is located in area 4, behind the area 4 green handle.  

1.  Open the Processor Door. The handle to open the door is above and to the left of Paper Tray 1.  
2.  Locate the area 4 green handle which is approximately 72 mm (2 inches) directly below the left side 

of Tray 2.  

3.  Raise the green handle and the baffle that is attached, until it locks into place.  

 

 

4.  Locate the Q861 Sensor under the baffle. The sensor is in the front left corner and approximately 

76 mm (3 inches) back from the handle. 
 

 

 
CAUTION: To avoid damage to the machine, do not use any liquids or solvents of any kind 
to clean the Q861 Sensor.  

5.  Gently rub a dry cleaning pad against the underside of the sensor, as illustrated, and move it left to 

right to clean the sensor.