Xerox DocuTech 180 HighLight Color System Mode D'Emploi
3-8
DocuTech 128/155/180 HighLight Color Operator Guide
Routine maintenance
Adding paper to trays 3, 4, 5, or 6
Paper Tray 3 is used to supply the largest volume of paper
required for your jobs. Trays 3, 5 and 6 (3-tray Interposer only) can
also be used to supply oversized paper for special jobs. Paper in
Tray 4 is only used for post-process insertion.
These trays lower one ream at a time as paper is added. More
than one ream can be loaded by pressing the Tray unlock button
again after the tray is fully opened.
Follow the described steps in the previous section to add paper to
Trays 3, 4, 5 or 6.
required for your jobs. Trays 3, 5 and 6 (3-tray Interposer only) can
also be used to supply oversized paper for special jobs. Paper in
Tray 4 is only used for post-process insertion.
These trays lower one ream at a time as paper is added. More
than one ream can be loaded by pressing the Tray unlock button
again after the tray is fully opened.
Follow the described steps in the previous section to add paper to
Trays 3, 4, 5 or 6.
Using the custom transfer assist blade
The custom transfer assist blade in the printer assures good print
quality for your jobs. A kit is available allowing you to customize
the transfer assist blade for use with nonstandard paper sizes.
You cannot use the custom transfer assist blade for print jobs that
use more than one paper size. In addition, the following paper
lengths cannot use the blade:
In U.S. markets
quality for your jobs. A kit is available allowing you to customize
the transfer assist blade for use with nonstandard paper sizes.
You cannot use the custom transfer assist blade for print jobs that
use more than one paper size. In addition, the following paper
lengths cannot use the blade:
In U.S. markets
– 11.1 to 11.4 inches/282 to 290 mm
– 11.8 to 12.1 inches/300 to 307 mm
– 13 to 13.5 inches/330 to 343 mm
– 11.8 to 12.1 inches/300 to 307 mm
– 13 to 13.5 inches/330 to 343 mm
In non-U.S. markets
– 11.1 inches to 11.4 inches/282 to 290 mm
– 11.8 inches to 12.1 inches/300 to 307 mm
– 11.8 inches to 12.1 inches/300 to 307 mm
NOTE: With these paper sizes, transfer efficiency may be
reduced.
reduced.
CAUTION: To avoid damage to the photoreceptor, you must set
the tray size with the transfer assist blade.
the tray size with the transfer assist blade.
Installing the
custom transfer
assist blade
The custom transfer assist blade comes in a package containing
detailed instructions. Be sure you follow the instructions carefully.
detailed instructions. Be sure you follow the instructions carefully.
CAUTION: To prevent damage to the system, have your service
representative show you the procedure before you attempt to
customize and install a transfer assist blade for the first time.
representative show you the procedure before you attempt to
customize and install a transfer assist blade for the first time.
Setting tray size with
the custom transfer
assist blade
When you are using the custom transfer assist blade, you must
set the tray length. Use the following two tables to determine the
tray length setting to use.
set the tray length. Use the following two tables to determine the
tray length setting to use.