Xerox DocuTech 180 HighLight Color System ユーザーガイド

Paper Tray 3 is used to supply the largest volume of paper 
required for your jobs. Trays 3, 5 and 6 (3-tray Interposer only) can 
also be used to supply oversized paper for special jobs. Paper in 
Tray 4 is only used for post-process insertion. 
These trays lower one ream at a time as paper is added. More 
than one ream can be loaded by pressing the Tray unlock button 
again after the tray is fully opened.
Follow the described steps in the previous section to add paper to 
Trays 3, 4, 5 or 6. 

The custom transfer assist blade in the printer assures good print 
quality for your jobs. A kit is available allowing you to customize 
the transfer assist blade for use with nonstandard paper sizes.
You cannot use the custom transfer assist blade for print jobs that 
use more than one paper size. In addition, the following paper 
lengths cannot use the blade:
In U.S. markets

– 11.1 to 11.4 inches/282 to 290 mm
– 11.8 to 12.1 inches/300 to 307 mm
– 13 to 13.5 inches/330 to 343 mm

In non-U.S. markets

– 11.1 inches to 11.4 inches/282 to 290 mm
– 11.8 inches to 12.1 inches/300 to 307 mm

NOTE:  With these paper sizes, transfer efficiency may be 
reduced.

CAUTION:  To avoid damage to the photoreceptor, you must set 
the tray size with the transfer assist blade.

The custom transfer assist blade comes in a package containing 
detailed instructions. Be sure you follow the instructions carefully.

CAUTION:  To prevent damage to the system, have your service 
representative show you the procedure before you attempt to 
customize and install a transfer assist blade for the first time.

When you are using the custom transfer assist blade, you must 
set the tray length. Use the following two tables to determine the 
tray length setting to use.