Xerox Xerox Versant 80 Press with Xerox Versant 80 EX 80 Print Server Mode D'Emploi
Recommended solution
Possible cause
Fault code
Remove all paper from the stacker tray.
The stacker tay is full
024-980
Remove all paper from the Finisher top
tray.
tray.
The top tray is full
024-981
Remove all paper from the stacker tray
and remove any other obstructions.
and remove any other obstructions.
The Finisher stacker tray
lower safety warning is on
lower safety warning is on
024-982
Remove all paper from the Booklet tray.
The Finisher Booklet tray is
full
full
024-983
Remove all paper from the Booklet tray.
The Booklet stapler low staple
signal is on
signal is on
024-984, 024-985
Remove all paper fromthe tray. Set the
output tray for three-fold. Check that the
folder tray is correctly attached and set.
output tray for three-fold. Check that the
folder tray is correctly attached and set.
The Booklet folder tray is full
024-987, 024-988
Power Off/On the press. Resend the print
job if needed. If fault persists, contact
Customer Support Center.
job if needed. If fault persists, contact
Customer Support Center.
A communication error has
occurred with the Finisher
occurred with the Finisher
047-320
Remove and empty the waste container
and then reinstall it completely.
and then reinstall it completely.
The Punch Waste Container
is full or near full
is full or near full
112-700
Confirm the staple position and try to
print again.
print again.
The settings for stapling are
canceled and prints the data
canceled and prints the data
116-790
Confirm the punching position and try to
print again.
print again.
The settings for punching are
canceled
canceled
124-705
Confirm the folding settings and try to
print again.
print again.
The settings for folding are
canceled
canceled
124-706
Decrease the number of pages, or cancel
the stapling settings. Resend the print job.
the stapling settings. Resend the print job.
The number of pages exceeds
the number of pages that can
be stapled
the number of pages that can
be stapled
124-709
Fault Codes - SquareFold Trimmer Module
If a fault occurs in the SquareFold Trimmer Module, a fault message displays. The
following table provides a list of fault codes for this finisher module and of related fault
codes.
following table provides a list of fault codes for this finisher module and of related fault
codes.
Note
The top covers cannot be opened during normal operation or when the press is idle. The
covers can be opened only when an indicator is lit and a fault occurs within the finisher
module. For indicator details, refer to the control panel information.
covers can be opened only when an indicator is lit and a fault occurs within the finisher
module. For indicator details, refer to the control panel information.
14-31
Xerox
®
Versant
®
80 Press
User Guide
Press Problem Solving