Zanussi ZCI68300XA Manuel D’Utilisation

To replace the glass panels, do the

same steps in reverse. Before you

lower the trim, attach the A trim part

to the door. Refer to the image.

Put a cloth on the bottom of the interior of the

appliance. It prevents damage to the lamp glass

cover and the cavity.

Danger of electrocution! Disconnect

the fuse before you replace the

lamp.

The lamp and the lamp glass cover

can be hot.

1. Deactivate the appliance.

2. Remove the fuses from the fuse box or

deactivate the circuit breaker.

The back lamp

The lamp glass cover is at the back

of the cavity.

1. Turn the lamp glass cover counterclockwise

to remove it.

2. Clean the glass cover.

3. Replace the oven lamp with a suitable 300

°C heat-resistant oven lamp. 

Use the same oven lamp type.

4. Install the glass cover.

Refer to Safety chapters.

You cannot activate the appli-

ance.

The appliance is not connected

to an electrical supply or it is

connected incorrectly.

Check if the appliance is correct-

ly connected to the electrical

supply.

You cannot activate the appli-

ance.

The fuse is released.

Make sure that the fuse is the

cause of the malfunction. If the

fuse releases again and again,

contact a qualified electrician.

You cannot activate or operate

the hob.

You touched 2 or more sensor

fields at the same time.

Touch only one sensor field.

You cannot activate or operate

the hob.

STOP+GO function operates.

Refer to "Hob - Daily use" chap-

ter.

You cannot activate or operate

the hob.

There is water or fat stains on the

control panel.

Clean the control panel.

An acoustic signal sounds and

the hob deactivates.

An acoustic signal sounds when

the hob is deactivated.

You put something on one or

more sensor fields.

Remove the object from the sen-

sor fields.

Residual heat indicator does not

come on.

 The zone is not hot because it

operated only for a short time.

If the zone operated sufficiently

long to be hot, speak to an Au-

thorised Service Centre.