Zanussi ZCI68300XA Manuel D’Utilisation

Automatic Heat Up function does

not operate.

The zone is hot.

Let the zone become sufficiently

cool.

Automatic Heat Up function does

not operate.

The highest heat setting is set.

The highest heat setting has the

same power as the function.

The heat setting changes be-

tween two levels.

Power management function op-

erates.

Refer to "Hob - Daily use" chap-

ter.

The sensor fields become hot.

The cookware is too large or you

put it too near to the controls.

Put large cookware on the rear

zones if possible.

 comes on the hob display.

Automatic Switch Off operates.

Deactivate the hob and activate it

again.

 comes on the hob display.

The Child Safety Device or the

Lock function operates.

Refer to "Hob - Daily use" chap-

ter.

 comes on the hob display.

There is no cookware on the

zone.

Put cookware on the zone.

 comes on the hob display.

The cookware is incorrect.

Use the correct cookware.

Refer to "Hob - Hints and tips"

chapter.

 comes on the hob display.

The diameter of the bottom of the

cookware is too small for the

zone.

Use cookware with correct di-

mensions.

Refer to "Hob - Hints and tips"

chapter.

The oven does not heat up.

The oven is deactivated.

Activate the oven.

The oven does not heat up.

The clock is not set.

Set the clock.

The oven does not heat up.

The necessary settings are not

set.

Make sure that the settings are

correct.

The lamp does not operate.

The lamp is defective.

Replace the lamp.

The display shows "12.00".

There was a power cut.

Reset the clock.

Steam and condensation settle

on the food and in the cavity of

the oven.

You left the dish in the oven for

too long.

Do not leave the dishes in the

oven for longer than 15 - 20 mi-

nutes after the cooking process

ends.

If you cannot find a solution to the problem

yourself, contact your dealer or an Authorised

Service Centre.

The necessary data for the service centre is on

the rating plate. The rating plate is on the front

frame of the appliance cavity. Do not remove

the rating plate from the appliance cavity.